Hi Opal! I have just started to use Opal on my Mac and think that it’s great. I have one suggestion. I currently have a block set that I cannot change or remove, which is fine. However, I’ve discovered that I cannot reboot my computer because Opal cannot quit during an active session. This is a problem for me as I switch back and forth between working on my laptop to using a dual monitor set-up which often requires a reboot to connect properly. Reading some of the related posts, I can see that this might have been implemented to prevent us from just rebooting out computers to get rid of a block. I would prefer if Opal would allow a reboot and then simply continue the block as is afterwards.